CAUTION:
To avoid personal injury, disconnect the fan cables before removing the fan from the device.
• S017
CAUTION:
Hazardous moving fan blades nearby. Keep fingers and other body parts away.
• S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted
with metal, which might result in spattered metal, burns, or both.
Attention:
• Read the “Installation guidelines” on page 85 to ensure that you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-
DoEcxrm2zKNpaKOdZ3f8Qc
.
Procedure
Step 1. Align the four tabs of the front system fan with the corresponding slots in the mounting area, and
align the two posts of the fan with the corresponding slots in the inner side of the chassis.
Step 2. Carefully slide the front system fan into the chassis until it snaps into place.
Note: Make sure the cables do not interfere with the two posts of the front system fan.
116
ThinkSystem ST250 V2 Maintenance Manual
To Next Page
Loading...
