Hot-swap drives
Use this section to understand the cable routing for server models with hot-swap drives.
See the configuration that is applied to the server.
• Software RAID
– “Four 3.5-inch drives” on page 75
– “Eight 3.5-inch drives” on page 77
– “Eight 2.5-inch drives” on page 79
• Hardware RAID
– “Four 3.5-inch drives with one 8i RAID adapter” on page 76
– “Eight 3.5-inch drives with one 8i RAID adapter” on page 78
– “Eight 2.5-inch drives with one 8i RAID adapter” on page 80
– “Sixteen 2.5-inch drives with one 16i RAID adapter” on page 81
– “Sixteen 2.5-inch drives with two 8i RAID adapters” on page 82
– “Four 3.5-inch and eight 2.5-inch drives with one 16i RAID adapter” on page 83
– “Four 3.5-inch and eight 2.5-inch drives with two 8i RAID adapters” on page 84
Four 3.5-inch hot-swap drives
Use this section to understand the cable routing for server models with four 3.5-inch hot-swap drives.
Following are the options available for this configuration:
• “Software RAID” on page 75
• “One 8i RAID adapter” on page 76
74
ThinkSystem ST250 V2 Maintenance Manual
To Next Page
Loading...
