Hot-swap drives
Use this section to understand the cable routing for server models with hot-swap drives.
See the configuration that is applied to the server.
• Software RAID
– “Four 3.5-inch drives” on page 49
– “Eight 3.5-inch drives” on page 51
– “Eight 2.5-inch drives” on page 53
• Hardware RAID
– “Four 3.5-inch drives with one 8i RAID adapter” on page 50
– “Eight 3.5-inch drives with one 8i RAID adapter” on page 52
– “Eight 2.5-inch drives with one 8i RAID adapter” on page 54
– “Sixteen 2.5-inch drives with one 16i RAID adapter” on page 55
– “Sixteen 2.5-inch drives with two 8i RAID adapters” on page 56
– “Four 3.5-inch and eight 2.5-inch drives with one 16i RAID adapter” on page 57
– “Four 3.5-inch and eight 2.5-inch drives with two 8i RAID adapters” on page 58
Four 3.5-inch hot-swap drives
Use this section to understand the cable routing for server models with four 3.5-inch hot-swap drives.
Following are the options available for this configuration:
• “Software RAID” on page 49
• “One 8i RAID adapter” on page 50
48
ThinkSystem ST250 V2 Maintenance Manual
To Next Page
Loading...
