After this task is completed
1. Install one of the following:
• Another optical drive or a tape drive. See “Install an optical drive” on page 155 or “Install a tape drive”
on page 215.
Note: A tape drive must be installed into the lower optical drive bay.
• The EMI-protective shield to the chassis and the plastic bay filler to the front bezel.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install an optical drive
Follow instructions in this section to install an optical drive.
About this task
To avoid potential danger, read and follow the following safety statements.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
• S006
Chapter 4. Hardware replacement procedures 155
To Next Page
Loading...
