Lenovo ThinkSystem ST250 V2 - Power Supply Replacement; Remove the Fixed Power Supply

Figure 96. Installing the power distribution board cover
After this task is completed
• Connect the cables to the corresponding connector on the system board. See “System-board
components” on page 27 and “Redundant power supplies” on page 69.
• Complete the parts replacement. See “Complete the parts replacement” on page 217.
Power supply replacement
Follow instructions in this section to remove and install a fixed or redundant power supply unit.
Remove the fixed power supply
Follow instructions in this section to remove the fixed power supply.
About this task
To avoid potential danger, read and follow the following safety statements.
• S001
170 ThinkSystem ST250 V2 Maintenance Manual