Figure 92. Removing the power distribution board of the fixed power supply
After this task is completed
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the power distribution board of the fixed power supply
Follow instructions in this section to install the power distribution board of the fixed power supply.
About this task
To avoid potential danger, read and follow the following safety statements.
• S001
DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
– Connect all power cords to a properly wired and grounded electrical outlet/source.
– Connect any equipment that will be attached to this product to properly wired outlets/sources.
– When possible, use one hand only to connect or disconnect signal cables.
– Never turn on any equipment when there is evidence of fire, water, or structural damage.
– The device might have more than one power cord, to remove all electrical current from the
device, ensure that all power cords are disconnected from the power source.
• S002
164
ThinkSystem ST250 V2 Maintenance Manual
To Next Page
Loading...
