Lenze 8400 - System Requirements; Basics of Positioning

2 Features of the technology application
2.3 System requirements
8
Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.3 System requirements
The technology application was created with the L-force »Engineer« V2.20 and can only be used
with the versions V2.20 or higher.
Software
Hardware
2.4 Basics of positioning
Positioning means that a workpiece/tool or material is moved from a starting position  to a
defined destination :
To carry out positioning, a travel profile has to be stored in the drive controller for at least the
following profile parameter:
Product Order designation from version
L-force »Engineer« HighLevel ESPEV-EHNNN 2.20
Product Order designation from hardware
version
from software
version
Inverter Drives 8400 TopLine C E84AVTCxxxxx VD 13.00
Icon Profile parameter
Position
Target position or distance to be traversed.
Velocity
Maximum speed during the positioning process.
Acceleration
Maximum acceleration during the positioning process.
Delay
Maximum deceleration during the positioning process.

v [unit/s]
t [s]
A
B
C D
A
B
C
D