Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05 5
1 About this documentation
1.3 Terminology used
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1.3 Terminology used
Term Meaning
Engineering Tools Software solutions for simple engineering at all stages
»EASY Navigator« – Ensures easy operator guidance
• All practical Lenze engineering tools at a glance
• Tools can be selected quickly
• Clearly arranged, simplifying the engineering process from the start
»EASY Starter« – Simple tool for service technicians
• Especially developed for the commissioning and maintenance of Lenze
devices
• Graphical user interface with few buttons
• Simple online diagnostics, parameterisation and commissioning
• No risk of accidentally changing the application
• Ready applications can be loaded to the device
»Engineer« – Multi-device engineering
• For all products from our L-force portfolio
• Practice-oriented user interface
• Easy handling due to graphical user interfaces
• Suitable for all project stages (configuration, commissioning, production)
• Parameter setting and configuration
Code Parameter used for controller parameterisation or monitoring.
The term is usually called "index".
Subcode If a code contains several parameters, these are stored in "subcodes".
This Manual uses a slash "/" as a separator between code and subcode (e.g. "C00118/3").
The term is usually called "subindex".
Lenze setting This setting is the default factory setting of the device.
FB Editor Abbreviation for function block editor. Graphic interconnection tool which is available in the
»Engineer« for function block interconnections on the FB Editor.
Function block General designation of a function block for free interconnection in the FB Editor.
Ein Funktionsbaustein (kurz: "FB") kann mit einer integrierten Schaltung verglichen werden,
die eine bestimmte Steuerungslogik enthält und bei der Ausführung einen oder mehrere
Werte liefert.
Example: "L_Arithmetic_1" (FB for arithmetic operations)
Many function blocks are available several times (e.g. L_And_1, L_And_2, and L_And_3).
System block In the function block editor of the »Engineer«, system blocks provide interfaces to basic
functions, "free codes", and to the hardware of the inverter (e.g. to the digital inputs). Each
system block is available only once.
Port block Block for implementing the process data transfer via a fieldbus
LP Abbreviation for Lenze Port block
Example: "LP_CanIn1" (CAN1 port block)
LS Abbreviation for Lenze System block
Example: "LS_DigitalInput" (system block for digital input signals)
MCI Abbreviation for Motionbus Communication Interface (fieldbus interface)
The Inverter Drives 8400 can accommodate plug-in communication modules and can
therefore take part in the data transfer of an existing fieldbus system.
Technology
application
A technology application is a drive solution based on the experience and know-how of Lenze
in which function blocks interconnected to a signal flow form the basis for implementing
typical drive tasks.
USB diagnostic
adapter
The USB diagnostic adapter is used for the operation, parameterisation, and diagnostics of
the controller. Data are exchanged between the PC (USB connection) and the controller
(diagnostic interface on the front) via the diagnostic adapter. Order designation: E94AZCUS
To Next Page
Loading...
