Lenze 8400 - 1 About this Documentation; Document History

Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05 3
1 About this documentation
1.1 Document history
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1 About this documentation
This documentation described the software-based solution of a task. The transferability of the
described solution to the respective application case needs to be checked by the user. If required, the
user has to adapt the solution accordingly. Thus, physical aspects as e.g. drive dimensioning is not
part of this documentation.
Target group
This documentation addresses to all persons
• who want to use the "Position Sequencer" technology application for the 8400 TopLine inverter,
and
• who are familiar with handling the device and the »Engineer« software.
Validity
The information in this documentation are valid for the following technology applications:
Screenshots/application examples
All screenshots provided in this documentation are application examples. Depending on the
software version of the controller and the version of the installed »Engineer« software, the
screenshots in this documentation may differ from the representation in the »Engineer«.
 Tip!
Information and tools for Lenze products are provided in the download area at
http://www.lenze.com
 Download
1.1 Document history
 Danger!
The controller is a source of danger which may lead to death or severe injury of persons.
To protect yourself and others against these dangers, observe the safety instructions
before switching on the controller.
Please read the safety instructions provided in the 8400 mounting instructions and in
the 8400 hardware manual. Both documents are supplied with the controller.
Technology application from version
Position Sequencer 2.0
Version Description
1.0 07/2014 TD05 First edition