3 Short setup of the technology application
3.3 Step 2 (optional): Establish control via the fieldbus interface (MCI)
16
Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.3 Step 2 (optional): Establish control via the fieldbus interface (MCI)
In the default setting, the application is controlled via the digital input terminals. For higher
automated systems, mostly data bus systems are used for controlling the drives.
For control via the fieldbus interface (MCI), the user interface (area highlighted in turquoise) is to be
adapted accordingly in the function block editor.
• The assignment of the outputs on the left to the inputs on the right can be changed at will.
• The inputs on the right are permanently linked to functions of the application.
Tip!
By means of some simple configuration changes, control via the integrated CANopen
interface ("CAN on board") can also be implemented. The port blocks LP_CanIn and
LP_CanOut required for this are already provided in the interconnection.
To Next Page
Loading...
