Lenze 8400 - Page 17

Lenze · 8400 "Position Sequencer" technology application · Software manual · DMS 1.0 EN · 07/2014 · TD05 17
3 Short setup of the technology application
3.3 Step 2 (optional): Establish control via the fieldbus interface (MCI)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
The following sample illustration shows the interconnection required for achieving the Pre-
assignment of the process data input words described in the following subchapter:
[3-1] User interface for sequencer inputs, the application control word, and the speed override setpoint in the function block editor
Adaptation of the user interface for a control via the fieldbus interface (MCI)