Lenze E82MV152_4B - Page 225

Appendix
Code table
14−24
L
EDB82MV752 EN 5.2
Code IMPORTANTPossible settings
No. SelectionLenzeName
C0150
*
Controller status
word 1 (parameter
channel)
Bit Assignment
 Scan of the controller status via
parameter channel. The most important
status information are grouped as bit
pattern.
 Some bits can be freely assigned to
internal digital signals
 Configuration in C0417
 In keypad: display only (hexadecimal)
0 Mapping of C0417/1
1
0
1
Pulse inhibit (DCTRL1−IMP)
Power outputs enabled
Power outputs inhibited
2 Mapping of C0417/3
3 Mapping of C0417/4
4 Mapping of C0417/5
5 Mapping of C0417/6
6
0
1
Output frequency = 0 (DCTRL1−NOUT=0)
false
true
7
0
1
Controller inhibit (DCTRL1−CINH)
Controller enabled
Controller inhibited
11|10|9|8 Controller status
0000 Controller initialization
0001
Mains voltage off (at external supply of the
control section ofthe drive controller)
0010
Switch−on inhibit
0011
Operation inhibited
0100
Flying−restart circuit active
0101
DC−injection brake active
0110
Operation enabled
0111
Message active
1000
Active error
12
0
1
Overheat warning (DCTRL1−OH−WARN)
No warning

max
− 5 °C reached
13
0
1
DC−bus overvoltage (DCTRL1−OV)
No overvoltage
Overvoltage
14 Mapping of C0417/15
15 Mapping of C0417/16
C0151
*
Controller status
word 2 (parameter
channel)
Bit Assignment
 The bits can be freely assigned to
internal digital signals
 Configuration in C0418
 In keypad: display only (hexadecimal)
0 ... 15 Mapping of C0418/1 ... C0418/16
C0155
*
Extended status
word
Bit Assignment
0 not ready for operation (NOT DCTRL−RDY)
1 not assigned
2 I
max
(MCTRL1−IMAX)
3 Pulse inhibit (DCTRL1−IMP)
4 not assigned
5 Controller inhibit (DCTRL1−CINH)
6 TRIP (DCTRL1−TRIP)
7 not assigned
8 Collective message
(DCTRL1−OH−PTC−LP1−FAN1−WARN)
9 PAR B0 (DCTRL1−PAR−B0)
10 PAR B1 (DCTRL1−PAR−B1)
11 ... 15 Reserved