8400 StateLine C | Operating instructions
Before commissioning
General notes on parameters
16 L from Firmware V06.00 - DMS 1.1 EN - 11/2011
Keypad display and control elements
LCD display
Headline
In the menu level: Menu name
In the parameter level: Parameter name
Three-part display
In the menu level: List of available menus
In the parameter level: Code/subcode and setting or actual value
Device status
Controller is switched on
Pulse inhibit is active
Controller is enabled
System fault is active
Controller is inhibited
"Fault" device status is active
Quick stop is active
Device status "Trouble" active
Current limit exceeded
Device status "TroubleQSP" active
Speed controller 1 in the limitation
A warning is indicated
Function - left function key Function - right function key
Change parameter setting
(change to editing mode)
Accept change in the controller
(no saving with mains failure protection
)
Back to main menu
Abort (discard change)
Parameter can only be changed when the controller is inhibited.
Save all parameter settings in the memory module safe against mains failure
Control elements
Execute the function assigned to the function key (see LCD display)
Execute the stop function set in C00469 (Lenze setting: Inhibit controller)
Deactivate stop function again (Lenze setting: Enable controller again)
In the menu level: Select menu/submenu
In the parameter level: Select parameter
In the editing mode: Change marked digits or select list entry
In the menu level: Select submenu/change to parameter level
In the editing mode: Cursor to the right
In the menu level: One menu level higher (if available)
In the parameter level: Back to menu level
In the editing mode: Cursor to the left
WXST VYR
+HDGOLQH
7ULSOHOLQHGLVSOD\
&XUUHQWIXQFWLRQ
ULJKWIXQFWLRQNH\
&XUUHQWIXQFWLRQ
OHIWIXQFWLRQNH\
/&'GLVSOD\
'HYLFHVWDWH
,QPDQXDOFRQWUROPRGH
6WDUWPRWRU
,QPDQXDOFRQWUROPRGH
6WRSPRWRU
To Next Page
Loading...
