Lenze E84AVSC - Page 17

from Firmware V06.00 - DMS 1.1 EN - 11/2011 L 17
8400 StateLine C | Operating instructions
Before commissioning
General notes on parameters
Menu structure
In the keypad, the parameters are classified into various menus and submenus.
 The USER menu includes a selection of frequently used parameters.
( 21)
 The Code list contains all parameters.
 The Go to param function enables you to reach the corresponding parameter directly.
 The Logbook logs all errors and their chronological history.
 The Diagnostics menu contains diagnostic/display parameters for displaying device-
internal process factors, current actual values and status messages.
General operation
[5-1] Example: Change parameter with the keypad
1. Use the / navigation keys to select the
desired menu.
–Use the / navigation keys to reach a
higher/lower menu level.
–Use the  function key to return to the
main menu.
2. Use the / navigation keys to select the
parameter to be set within a submenu.
3. In order to select another subcode in case of
a parameter with subcodes:
– Press the navigation key  to change tot
he editing mode for the subcode.
– Use the navigation keys to set the
desired subcode.
4. Use the  function key to switch over to
the editing mode.
5. Use the navigation keys to set the desired
value.
6. Use the  function key to accept the
change and to leave the editing mode.
– Use the  function key to leave the
editing mode without accepting the
change.
Load Lenze setting
C00002/001
Off / Finished
EDIT
Par1 8400 StateLine C
SAVE
Code list
Go To Param
USER - Menu
Fixed setpoint 1
C00039/001
40.00 %
EDIT
Fixed setpoint 2
60.00 %
EDIT
C00039/002
Fixed setpoint 2
C00039/002
ESC
60.00 %
OK
1.
2.
3.
5.
4.
6.