Lenze E84DGFCA Series - 7.6 Data transmission slave 2 (AS-i profile 7.A.7)

Lenze · Decentralised frequency inverter 8400 motec (AS-Interface option) · EDS84DMOTASI EN 5.0 - 02/2019 37
Data transfer
Data transmission slave 2 (AS-i profile 7.A.7)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.6 Data transmission slave 2 (AS-i profile 7.A.7)
AS-i profile 7.A.7 for slave 2 is used for communication units from firmware version 3.0 onwards.
Accessing the data bits
1)
The bit is queried in cycles of 10 ms.
2)
The bit is queried in cycles of 20 ms.
Bits Signal / I/O mapping Description / standard connection with ...
inputs
DI0 LP_Network_Out: MCI_bState_B0 C00621/30: not connected
DI1 LP_Network_Out: MCI_bState_B1 C00621/31: not connected
DI2 Digin_bln1 The function of these inputs cannot be selected in the
»Engineer«.
Can be used to monitor the digital inputs if the Drive Unit is
in the "offline" status.
DI3 Digin_bln3
outputs
DO0
1)
LP_Network_In: MCI_bCtrl_B0 C00701/6: LS_DigitalInput: bIn1
DO1
1)
LP_Network_In: MCI_bCtrl_B1 C00701/7: LS_DigitalInput: bIn2
DO2
1)
LP_Network_In: MCI_bCtrl_B2 C00701/17: LS_ParFix: bTrue
DO3
2)
LP_Network_In: MCI_bCtrl_B3 C00701/18: not connected
The bit is toggled, since it is also used for A/B addressing.