Lenze EtherNet/IP 8400 - Page 65

Lenze · E84AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 10/2013 · TD17 65
8 I/O data transfer (implicit messages)
8.4 I/O configuration in the »Engineer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
For some data words, you can also assign signals to the individual bits via the and
buttons.
 Select the signals and then confirm the selection with OK.
5. Use the standard device code C00002 to execute the command "11: Save all parameter
sets".
The changed settings are activated and saved with mains failure protection.