Lenze EZAEDE1001 - Copying Memory Data; Powering Down the Device

Lenze EDBZAEDE1001 DE/EN/FR/ES/IT 1.0 11
EN
Operation 3
POWER LED
STATE LED Description State Description
Red Green NOTE: MMC = Memory Module Copier
m m
Both Off No power
m
Red: slow flash/3 sec; Green: Off MMC Off; Battery Charging - USB charger connected
m
Red: Off; Green: slow flash/3 sec MMC Off: Battery Charged - USB charger connected
m
Red: Off; Green On MMC On; Battery charged or Battery operation
Red: slow flash/3 sec; Green: On MMC On; Battery charging
Alternating: Red: flash; Green:
flash
MMC On; Battery error: Battery over-charged or temperature
too high
Green: On 7 sec then 2 flashes
R & G
MMC On, Low Battery Warning
MASTER LED
STATE LED Description State Description
Red Green
m m
Both Off No memory module in the Master socket
m
Red: Off; Green: On Memory module inserted in Master socket; Successful
Copy if Slave =
m
Red: Off; Green: double flash
synchronized with Slave
Copying in progress
m
Red: On or double flashing; Green Off Copy operation failed. Refer to the error code table.
SLAVE LED
STATE LED Description State Description
Red Green
m m
Both Off No memory module in the Slave socket
m
Red: Off; Green: slow flash Memory module inserted in Slave socket
m
Red: Off; Green: double flash synchronized
with Master
Copying in progress
m
Red: Off; Green On Last Copy operation finished successfully
m
Red: On or double flashing; Green Off Copy operation failed. Refer to the error code table.
ERROR CODES
STATE LED Description Error Description
Red Green
m
Steady Green No Error. Operation is successful
m
Single blink Red Data incompatible
m
Two blinks Red Memory module verification failed
m
Three blinks Red Slave memory module different than master
1
m
Four blinks Red Unknown module
m
Five blinks Red Access to memory module failed/timeout
m
Steady Red General access failure