Preface and general information
1-2
L
MA9300PLC EN 1.4
1.2 About these Instructions
• These Instructions help to mount and test the 93XX Servo PLC. The default setting for the
controller is configuration 1010. The chapter Commissioning
(^ 5-1) gives instructions how to
easily and quickly test the 93XX Servo PLC and the connected motor.
• Please observe the safety notes given in these Instructions.
• All persons working on and with the Servo PLC must have the Instructions available and must
observe the information and notes relevant for their work.
• The Mounting Instructions must always be in a complete and perfectly readable state.
• Further information about the controller can be obtained from the Catalog and the Manual.
1.2.1 Terminology used
Term In the following text used for
93XX Any servo controller of type 9321 ... 9332
Controller 93XX Servo PLC
Drive system Drive systems with Servo PLC 93XX and other Lenze drive components
DDS Drive PLC Developer Studio, software tool for the development of PLC programs
GDC Global-Control (software tool for parameter setting of drives)
1.3 Packing list
Packing list Important
• 1 93XX Servo PLC
• 1 Mounting Instructions
• 1 accessory kit (bits and pieces for
mechanical and electrical
installation)
After receipt of the delivery, check immediately whether the items delivered match the
accompanying papers.Lenze does not accept any liability for deficiencies claimed subsequently.
Claim
• visible transport damage immediately to the forwarder.
• visible deficiencies/incompleteness immediately to your Lenze representative.
à The following is required for programming the 93XX Servo PLC
– DDS (Drive PLC Developer Studio)
– 1 System bus adapter
These tools are not included in the packing list.
To Next Page
Loading...
Need help?
General