EDS94AYCEN EN 9.0 - 09/2012 L 67
E94AYCEN communication manual (Ethernet)
Index
I
Identification 13
Initial switch-on 37
Installation 19
Interface 15
Interfaces 14
Internal voltage supply 25
IP address 31
L
Lease time 34
LED status displays 52
M
MAC-ID 32
Mechanical installation 20
N
Nameplate 13
Network Analyzer (output) 30
Network topology 15
Notes used 10
O
Operating conditions 15
Output 30
Output of the »Network Analyzer« 30
P
Parameter data transfer 38
Parameter reference 54
Parameters of the communication module for slot
MXI1
56
Parameters of the communication module for slot
MXI2
60
Parameters of the standard device that are relevant to
communication
54
Pin assignment 22
Port 15
Product description 13
Product features 14
Protection against uncontrolled restart 37
Protection of persons 12
Protective insulation 16
R
Reading parameters from the controller 40
Residual hazards 12
Resolved Gateway-Address (C13008) 59
Resolved Gateway-Address (C14008) 63
Resolved IP-Adress (C13004) 58
Resolved IP-Adress (C14004) 62
Resolved Subnetmask (C13007) 59
Resolved Subnetmask (C14007) 63
Resp. to imp. device config. (C00615) 54
Resp. to new module in MXI1 (C00636) 54
Resp. to new module in MXI2 (C00637) 55
S
Safety instructions 11
Safety instructions (representation) 10
Screenshots 5
Setting the address 28
Specification of the Ethernet cable 23
Status displays 52
Structure of the Ethernet cable 23
Structure of the Ethernet data telegram 39
Subnet mask 31
Switch latency 15
Switching method 15
T
Table of attributes 64
Target group 6
Technical data 15
Telegram examples 45
Terminology used 9
Terms 9
Transmission abort 42
Transmission mode 15
U
Use of DHCP (C13005) 58
Use of DHCP (C14005) 62
User data areas 41
Using the communication module 13
V
Validity of the documentation 6
Voltage supply 15, 25
W
Writing parameters to the controller 40
To Next Page
Loading...
