Lenze PROFIBUS E84AYCPM - Page 33

6 Commissioning
6.3 Setting the station address
33
Lenze · E84AYCPM communication module (PROFIBUS®) · Communication Manual · DMS 5.0 EN · 11/2012 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Setting the station address via the »Engineer«
In the »Engineer«, the station address can be set via the Settings tab.
Impermissible addresses are displayed in red in the Station address (code C13899
).
Save the changed settings with device command C00002/11 (save all parameter sets).