Leroy-Somer DIGIDRIVE SE2.5T User Manual

This manual is to be given to
the end user
1
0V
RP
Reference A1
(analogue voltage input)
+10V
0V (negative logic)
Reference A2
(analogue current input)
Analogue output (motor frequency)
+24V (positive logic)
Logic output (zero frequency)
Unlock
Run forward/Stop
Run reverse/Stop
A1/A2 reference selection
Jog
(see 15 in section 4.8)
Fault relay
2
3
4
5
6
7
PL1
PL2
8
9
10
11
12
13
14
15
16
DIGIDRIVE
Variable speed drive
Installation and commissioning
Réf. 3218 GB - 4.33 / d - 02.02

Leroy-Somer DIGIDRIVE SE2.5T Specifications

General

Brand	Leroy-Somer
Model	DIGIDRIVE SE2.5T
Category	Inverter
Language	English

Summary

SAFETY AND OPERATING INSTRUCTIONS FOR VARIABLE SPEED DRIVES

1 - General

General precautions and information regarding variable speed drives.

2 - Use

Guidelines and directives for the intended use of variable speed drives.

3 - Transportation, storage

Instructions for the safe transport and storage of the equipment.

4 - Installation

5 - Electrical connection

6 - Operation

7 - Servicing and maintenance

FOREWORD

6 - MAINTENANCE

6.1 - Introduction and warning

Introduction to maintenance procedures and essential safety warnings.

6.2 - Care

Guidelines for the care and handling of the drive components.

7 - OPERATING EXTENSIONS

7.1 - Type 1 mains filters

Characteristics and specifications for Type 1 mains filters.

7.6 - Using the serial link

Instructions for using the RS 485 serial link for communication.

7.9 - Using Modbus RTU

Guidelines for using the Modbus RTU communication protocol.

8 - SUMMARY OF THE SETTINGS FOR YOUR APPLICATION