LevelOne GNS-2000 - Audible Warnings

7
fault (DHCP client) and it will beep once to indicate the reset
has occurred
 If the NAS administrator’s password is lost, press and hold
this button for 10 seconds. The password will then be cleared
(no password), and the NAS will beep twice.
USB Eject Button 1
Press and release to prepare the USB device for removal. When
the USB LED turns off, it is safe to remove the USB device.
USB Port 1 & 2
(Up/Down)
 Connect your USB Hard Disk Drive or USB Flash Drive here.
The USB HDD support FAT and NTFS (Read only) file for-
mat.
 Connect USB printer.
USB Eject Button 2
Press and release to prepare the USB device for removal. When
the USB LED turns off, it is safe to remove the USB device.
LAN connector
Use this to connect the NAS to your 10/100/1000BaseT hub.
Audible Warnings
Audible warnings are given by the following signals.
1 Beep
Reset button or power switch is pressed or system is ready to
use
3 Beeps
Repeated every 5
seconds for 3 minute.
Hard disk usage exceeds 98%