USB Devices
You can insert either USB HDD or USB Memory Disk (Flash Memory Disk) to USB port at
any time. Once the “USB 1” or “USB 2” LED on the front panel comes on and stays on, the
USB device is available for use.
For USB HDD, the NAS can recognize FAT and NTFS (Read only) file format.
Removing a USB device - Method A
1. Press the USB Eject button on the rear panel (Eject 1 for USB 1, Eject 2 for USB 2).
The GNS-2000 will beep.
2. Wait for the "USB" LED turn off.
3. Remove the USB device.
Removing a USB device - Method B
1. Run the Windows utility.
2. Select "Safely Remove Drive".
3. Select the desired GNS-2000.
4. Click the "Eject" button.
5. Wait for the "USB" LED turn off. (The Windows program will also display a message
when it is safe to physically detach the USB device.)
6. Remove the USB device.
Note: If the USB device is not removed, it will not be re-connected. You must remove and re-
insert the USB device to have it re-connected.
To share a printer, connect USB printer to this USB port. Install the driver of printer on your
PC. GNS-2000 supports printer server function.
To Next Page
Loading...
