Locate the power switch on the GNS-2000’s rear panel. Press it once to power on the
NAS.
5. Self-test
The GNS-2000 will run a brief self-test (2 or 3 seconds). During the self-test, all LEDs
of the NAS will be illuminated or flashing.
6. Booting up
When the self-test is complete, boot up will start. The Ready LED will blink continuous-
ly, and the LAN LED will blink occasionally. Boot up should take approximately 1-3
minutes.
7. Boot up completed
When the Ready LED stops blinking, and remains on, boot up is complete. If the Sta-
tus (Orange) LED stays on, or if the GNS-2000 repeatedly beeps, there is a hardware
problem. Consult the Troubleshooting section of this User Guide for possible solutions
Shutdown
To shutdown GNS-2000, press the power switch to start the shutdown sequence. Wait for
all LEDs to turn off.
To Next Page
Loading...
