LevelOne GNS-2000 - Date and Time Settings

38
System Screen
Identification
Server Name
If you wish, you can change the name of the NAS Server. Note that punc-
tuation and other special characters (e.g. * " / \ [ ] : ; | = , + ? < > ' ` ( ) #
$ %) cannot be used in the name.
Comment
Enter a comment if you wish (e.g. the location of the NAS Server). Note
that special characters (e.g. | \ , ' : ") cannot be used in it.
Workgroup
This should match the "Workgroup Name" on your PCs. If the Workgroup
name does not match, access to the NAS Server is still possible, but the
NAS Server will not appear when you click the "Browse Network" button
(for example, when adding a Network Printer). Note that punctuation and
other special characters (e.g. / ] \ [ : ; | = , + * ? " > < ' ` ) cannot be used in
the name.
Printer Name
Specify one name for the Printer Server. After you plug one printer into
one USB port, the Printer Name will occur in Network Neighborhood and
you can click it to install the Printer Server.
Date & Time
Time Zone
Select the correct time zone for your location.
Change System Date
and Time as Following
Check this box for data and time update. The date and time setting is not
sent to the server without check this box.
Date
Enter the local date. The NAS Server will set it own calendar according to
the date you provide.
Time
Enter the local time at your location. The NAS Server will set its own clock
according to the time you provide. Remember that this is not sent to the
Server until you click "OK".
NTP (Network Time Protocol)
Synchronize with Time
Server
If enabled, the NAS Server will synchronize its clock with a NTP (Network
Time Protocol) Server.
NTP Server
Enter the domain name or IP address of the NTP server you wish to use.
The NTP server can be a public server (on the Internet) or a local server
(on your own network). Note that special characters (e.g. " / \ [ ] : ; | = , +
* ? < > ' `) cannot be used in it.
Status
This shows the status of the NTP update procedure.
Synchronize ...
Select how often you want the NAS Server to synchronize its clock with
the specified NTP server. You can also specify the time of the next syn-
chronization. This allows you to specify that the synchronization should be
performed (for example) at 11.00 pm each day.
Sync Now
Use this button to synchronize with the NTP server immediately.