Specify the location in which music need be served iTunes Server.
If enabled, then the NAS will broadcast MP3 in specified folder, and user can
listen to them by music players such as WinAMP etc. This MP3 Broadcast
supports files with extension .mp3.
Specify the name of the MP3 Broadcast.
This port number is used for HTTP connections to MP3 Broadcast. The
default is 1234. If this is changed, you should use a number greater than
1024. In order to connect to the music broadcast via WinAMP etc, need add
a ":" and the port number after the address, e.g.:
HTTP://192.168.0.100:1234
This example assumes the NAS Server’s IP Address is 192.168.0.100, and
the port number is 1234.
Specify the order that MP3 should be broadcasted.
Order - Play by order.
Shuffle - Play by shuffle.
Specify the location in which MP3 need be broadcasted.
If enabled, the NAS can be located by compatible Media Adapters, using the
UPnP AV standard developed by Intel and its partners. Media content on the
NAS (in the Content Directories specified below) can then be accessed and
played by the Media Adapters.
Name of the Media Server that is displayed on client devices.
Directories where the Media Server shall scan for media content. You can
specify four Content Directories at most. You should click the "Browse" button
to select the desired folder. Each directory can be limited to a certain media
type. The default setting will scan for all content types.
Click this button to select Content Directory.
Click this button to save the settings on the page.
Click this button to cancel the modifications on the page.
To Next Page
Loading...
