7 Troubleshooting
For troubleshooting and failure analysis with the stand-alone controller LPC-300.1 the following procedure is
recommended:
▪ Check the status of the LEDs. The specific LEDs are described in Table 7.
▪ Use the ERROR codes on the display. The specific error codes are described in Table 9.
▪ A digital output on the “USER INTERFACE” connector indicates if the system is active.
However, the source of an error cannot be identified by this signal.
▪ If the problem is still not solved contact the Levitronix
Technical Service Department
(see Section 8)
8 Technical Support
For troubleshooting, support and detailed technical information contact Levitronix
Technical Service
Department:
Levitronix
Technical Service Department
Technoparkstr. 1
CH-8005 Zurich
Switzerland
Phone for US: 888-569 07 18
Phone for outside US: +1 888-569 07 18
E-Mail: TechSupport@levitronix.com
To Next Page
Loading...
