User Manual for BPS-300
www.levitronix.com
PL-4006-00, Rev07, DCO# 20-144
9 Appendix
9.1 Regulatory Status
9.1.1 CE Marking
The Centrifugal Pump System BPS-300, in its various configurations as listed below, is in conformity with the above
mentioned European Directives. The pump system is thought to be used in hydraulic circuits of production equipment of
the Semiconductor, Chemical and general machinery markets.
Pump head configurations consisting of pump casings
LPH-600.1 (PTFE, Flaretek 1”)
and impellers
LPI-600.2 (PFA)
Bearingless motors with 48V windings:
LPM-600.2 (3m PVC cables, AMP connector, ETFE coating)
Controller with 48V DC / 300 W inputs
LPC-300.1 (Stand-alone controller with user panel and enable input)
Motor controller adaptor cables of various length, air cooling module and others
Machinery Directive 2006/42/EC:
The machinery directive essentially has been followed by a risk analysis, according mitigation actions and a user manual
for safe operation. For the design and testing the following standards are used as a guideline:
Pumps for Fluids: basic requirements are followed.
Procedure for hydrostatic pressure testing in fluid pumps: used for max. pressure testing of pump head.
Safety for machinery – principles for risk assessments: used for system risk analysis.
EMC Directive 2014/30/EC:
The following standards of the EMC directive are tested and confirmed at a certified laboratory:
Generic standards, Immunity for industrial environments
Generic standards, Emission standard for industrial environments
9.1.2 Disposal of Equipment – WEEE Directive 2012/19/EU
Follow local legislation for disposal of equipment. In the European Union (EU) marked ( ) devices are governed by the
European WEEE Directive 2012/19/EU. Do not dispose with normal waste.
9.1.3 IECEE CB Safety Certification
Specific motors with pump heads and controllers of the Centrifugal Pump System BPS-300 are 3
rd
party
tested and certified by Electrosuisse following the IECEE CB Scheme according to the following safety
standards:
Safety requirements for electrical equipment for measurement, control and laboratory use.
The CB certification number is CH-7696.
9.1.4 NRTL/ETL Safety Certification and Marking
Specific motors with pump heads and controllers of the Centrifugal Pump System BPS-300 are tested by
the US national recognized laboratory (NRTL) Intertek according to the following safety standards:
Safety requirements for electrical equipment for measurement, control and laboratory (US Standard).
Safety requirements for electrical equipment for measurement, control and laboratory use (Canadian Standard).
Rotating Electrical Machines - General Requirements (US standard).
The ETL control number for the listing is 4010272.
To Next Page
Loading...
Need help?
General
