User Manual for BPS-4000
www.levitronix.com
PL-4016-00, Rev11, DCO# 18-057
1 Safety Precautions
The BPS-4000 pump system is designed to be used in industrial production machines and equipment
containing hydraulic circuits. Typical applications are Semiconductor and chemical manufacturing equipment.
Installation shall be done by qualified personnel only. Following safety precautions and all “CAUTION”,
“WARNING” and “DANGER” indications in the relevant sections shall be followed.
Do not under any circumstances open the controller or motor. Levitronix
®
does
not assume responsibility for any damage, which occurs under such
circumstances.
High magnetic field strength of pump impeller.
The pump system contains a rotor magnet with high field strength. This may
alter or damage the calibration of sensitive electronic devices and measuring
instruments in the immediate surroundings. Keep at a safe distance from
computers, monitors and all magnetic data storage media (e.g. disks, credit
cards, audio, video tapes etc.).
Hazardous voltage may be present.
The controller must be grounded and placed in a spill protected electrical
cabinet. Do not under any circumstances open the powered controller.
Always isolate the electrical power supply before making or changing
connections to the unit. To remove the power it is recommended to use an
isolating device.
Hazardous voltage is present until 60 sec after switch off. Do not handle the
controller during this time.
High magnetic field strength of pump impeller.
The pump system contains a rotor magnet with high field strength. Pace maker
may be influenced and magnetic forces may lead to contusions. Keep distance
to pace makers and handle impeller with care.
TOXIC CHEMICALS may be present.
When using the system to pump chemicals skin contact and toxic gases may
be hazardous to your health. Wear safety gloves and other appropriate safety
equipment.
Motors for ATEX / IECEx and Hazardous Location applications: only specific
types of motors LPM-4000 are classified for the use in Ex classified locations.
Refer to the corresponding section in the manual.