From the main time code menu, select =ADD”. Now select the edtt event number
by pressing the key directly above “r. Use the Soft knob to selet ‘K?,“, then press
STORE. This makes a complete copy of event#3 and places it into slot #4. Note
that Event #K3 and Event #4 now have the same time code adress.
PRESS CNTRL to return to the main time code menu.
Press EDIT, then select Edit #3. Now, press the key directly below “**” and use
the Soft knob to program PA:(parameter,Machine A).
Press the next button to the right to use the Soft knob to program the actual
parameter. Turn the Soft knob until the “RTIM” is displayed.
Press the next button to the right to use the Soft knob to select the final reverb
time. Adjust the value as close to 15 seconds as possible.
Finally, press the next button to the right. Turn the Soft knob clockwise to enter
frame duration values. (100 Fr will equal approximately 3 seconds.)
Press STORE. Event #3 should look like this:
Press the key directly above Y’, and repeat the above steps so that the display
looks like this:
Parameter glides which have been programmed into the Event List will be
viewed singly, as the event happens. If you am ViEWing two or more glides
which happen to be programmed for the same time code (as in the example
above), only the last entry will be displayed.
6-7
To Next Page
Loading...
