Lexicon 300 - Page 50

300 v 3.0 Owner’s Manual
Lexicon
The upper line of this page describes the current machine configuration (Single,
Dual Mono or Cascade). The information that appears here is determined by the
type of Setup currently running.
Eitherof the two left buttons on the botton allow selection of Input: ANALOG and
DIGITAL are available as choices with ail types of setups. AZ-L Dz-R (Analog/
Left, Digital/Right), or D>L A%? (DigitaVLeft, AnalogRight) is available for
selection in Dual Mono setups..
The two right buttons on the bottom row allow selection of Output: ANA+DlG is
available in all setup types. A(D Pre), orA(D Pst) and D(A Pre), or D(A Pst) are
available in Dual Mono setups. Cascade setups display choice between A(D
Pre, Mid or Pst) and D(A Pre, Mid or Pst) for patch point selection.
This upper line of this page describes the current format being input to the 300.
When no digital signal is present, the display will show “* l * l *” as above.
If the incoming audio signal is analog, selecting “Clk” allows Soft knob selection
of the system sample rate for analog operation: 43kH.z or 44.IkHz. (The
appropriate sample rate LEDs on the left side of the display will illuminate to
indicate the sample rate selected.) If the input is digital, the system will automatf-
tally lock to the sample rate of the incoming data and display”Lock.” Otherwise,
“***“will be displayed to indicate that the incoming digkal signal has not yet been
detected.
Either of the two left buttons on the botton allow selection of AES or SPDF as
output format.
The two right buttons on the bottom row allow you to specify the connector used
for audio input: XLR, RCA, or OPT.
3-24