lhe Algoiims and their Parameters
Stereo Adjuet Delay and Feedback Page
These controlsgive individual channel control overthe 5-second post-equalbra.
tion delay line.
5second, 10 milliseconds per step, mono control for the left channel.
LDLY
(Left Channel Coarse)
DLAY + LDLY must not total more than 5,000 milliseconds.
5second IO milliseconds per step, mono control for the right channel. RDLY
(Right Channel Coarse)
DLAY + FiDLY must not total more than 5,000 milliseconds.
Fine Sample Accurate Delays
These can be used for subtle time alignment adjustments. The 300 will correctly
displaythe resulting time shift asafunctionofthesampling rate.As many as500
samples can be added to any stereo/coarse delay setting for a maximum
possible delay per channel of 5 seconds + 500 samples.
48 kHz = 20.833 microseconds per sample
44.1 kHz = 22.676 microseconds per sample
32 kHz = 31.25 microseconds per sample
500-sample, 1 sample per step, mono fine adjust forthe left channel.
LFIN (Left Channel Fine)
500-sample, 1 sample per step, mono fiie adjust for the right channel.
RFIN (Right Channel Fine)
Two feedback paths are available per channel: overall and fine. Overall
feedback is the total delay of DLAY + L(Fl)DLY + L(R)FfN, and is useful for long
echo effects.
Fine Feedback is only around the Fine Delay and can be used for very short
delay effects and coloration.
All feedback gains are adjustable in 1% increments from -99% to +99%. If the
magnitudes of both feedback gains for a channel sum to more than lOO%, that
channel will take off and overload.
On the 300 Effects Feedback page, overall and fine are distinguished by upper
and lower case lettering:
LFBK z Overall Left Channel Feedback
Lfbk = Fine Left Channel Feedback
RFBK z Overall Right Channel Feedback
Flfbk = Fine Right Channel Feedback
4-21
To Next Page
Loading...
