Lexicon 300 - Page 93

300 V 3.0 Owner’s Manuaf
Lexicon
Single Setup
Presets contki.
Alaorithm
Rich Plate
Descriction
The old standard uxnes back to the future. Advancing the Soft knob
controls the reverb time negatively.
Rich Plate
This preset shines a little differently. Some close in pre-echoes gives
a strong impact to the original source.
Rich Plate
Rich Plate
Not youraverage brightplate-ratheraslightlydullversion which will
work very well on horn tracks, adding point and definition.
For drums and the like. Not bad on piano either.
i$P&% Contern-Plate
&&,@Q#
Rich Plate
Bright and splashy-sounding. Should work well to brighten a track
?W%
‘$?&$&$&
without getting too washy-sounding.
*~x$*~<@~
~~~~~~ *EN0 Plate
Rich Plate
Combines asweet combination of recirculating pm-echoes and bright
+:.$::~.$*:>$*.
::<:$:.::>$>w:>>;
sounding reverb. The Soft knob is negatively patched to RTIM and
$~$~~&~~~~~~
Delays 1 and 2.
Bright Plate Rich Plate
Slightly smaller version of Contem-Plate. Great of vocals. Some
strong pre-echoes to help the direct sound stand out.
* Round Plate Rich Plate Soft, but articulate. The Soft knob is patched to feedback paths
surrounding pre-echoes 1 and 2, which feedback into the
reverberator.
2 Frame Delay
Algorithm
Stereo Adjust
Description
Sets you up to fix audio sources. Null preset with pages for EQ,
delays, phase and channel swaps, and DC offset removal.
.:.:,!.::!.,
Telephone
Phase Invert
4 Frame Delay
MS Decode
*MultiEchoes
LFO Parmer
Stereo Adjust The right channel is phase reversed to the left. if you put a mono
signal into this program and pan the output returns left and right,
you’ll definitely twist your head off.
*NOTE This phase-reversed mono signal will also decode to the
surround channel if run through a surround decoder.
Stereo Adjust 66.3 ms of delay running at 44.1 kHz and 65.9 rns at 46kH.z.
Stereo Adjust 100 ms of delay at both operating frequencies.
I
Stereo Adjust 133 ms of delay at both operating frequencies.
I
I
Stereo Adjust Take a Z-channel Mid (left input) Side (right input) recording and this
program will properly decode to stereo output.
Stereo Adjust This preset combines echoes underthe control of the Soft knob. As
you advance the Soft knob, the delays will get longer.
I
!
Stereo Adjust This preset attaches the LFO to the Stereo Adjust balance control.
Once aaain. the LFO Rate determines the speed of the pan. This
preset ghouid be used from a pre-fade send’source.
Stereo Adjust No bottom end....ATALL.
I
I
I
I
I
I
I
I
I
I