EasyManua.ls Logo

Lexicon 300 - Page 97

Lexicon 300
153 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
300 V 3.0 Owner’s MCI~I.ICI
Lexicon
A true Dual-Mono pitch preset. Going to the Soft knob parameter location (in Setup Select mode) will enable ycu to advancs
the delay parameter in the Machine A effect.
MchA W&l3 ‘Up Shift Up Shift is a sweet sounding micrcshifl up +7cents. There is a slight “chorus sdge” due tc a
modest amount feedback around a 01% delay line. The Soft knob controls the delay line length.
MchB EPz806 Echo Down 14 cents down with a 258ms recirculating delay line. This effect works great either before cr
after a Reverb preset (in a Cascade Setup).
Send a vocal track into the left input and send a rncnc prefade drum premix into the right input.
MchA W610 Vocal Shifi This preset combines a shcrl delay line recirculating around a -7 cent pitch shifter.
MchB EB:902 DrumComp 3:i This is a bii mere agressive, with 7dB of boost below the selected threshold. A quick
release of 5Ems snaps up the volume. As with ail ccmpresscr presets, Threshold is the critical parameter.
This is a true “Dual.Mcnc” Setup. Any audio (analog cr digital) should be sent pre-fade cr inserted in a patch point.
MchA EAz901 EZ Camp 2:1 A nice preset to add to an overall mix. You may need to adjust Threshold to make ti work
for the particular signal you’re feeding it. The release parameter is set to gently fall away after 363ms.
MchB EB:902 DrumComp 3:l This is a bii mere agressive, with 7dB of bccst below the selected threshold. A quick
release of 58ms snaps up the volume. As with all ccmpresscr presets, Threshold is the critical parameter.
The LFO is set to 0.9OHz with aTriangle waveform, and is attached to both Machine Flange Glide Delays. Turning the LFO
faster will spaed things up, but may cause Machine Atc pitch too heavily. This preset cati be used with either mcnccrstereo
scurces, but discrete echoes will appear at the left output.
MchA ER607 LFO:FazeDlys Faze Dlys makes use of the LFO to the Flange Glide Delay (FDLY). The base delays are
set in different time domains: cne side at 1.9ms with a feedfctward gain: the other at 5.6 with a negative feed gain. As the
Glide passes cvereach base delay, the phase of each gain is changed. In between, the output is a mixture of each. Agreat
effect cn a tipping guitar sclc.
MchB EP609ChcrusThispreset makeswecf asmallvariaticn intheglidedelaytcmcdulatethescund.Theglide mcves
between 9.7ms and 11.8ms. Advancing the LFO to values near 1 SOHz to 2.0 Hz yields a nice chorusing effect. There are
nc other delay lines, but the output lines are channel+.vapped such that the left input passes to the right output and vice-
versa. In a Dual Mono Setup, this is ,cf ccwse, inaudible.
50

Table of Contents

Related product manuals