Lexmark C510 - Top Cover Assembly Removal

4-18 Service Manual
5021-0XX
Top cover assembly removal
1. Remove cleaning roller cover. See “Cleaning roller cover
removal” on page 4-6.
2. Remove photodeveloper cartridge. See “Photodeveloper
cartridge removal” on page 4-11.
3. Open rear cover assembly.
4. Open front cover.
5. Remove screw (A) from operator panel.
6. Rotate rear of operator panel and operator panel cover up.
7. Pull operator panel forward and turn it over.
8. Disconnect operator panel cable.
9. Remove two screws (B) from top cover assembly.