2-14 Service Manual
5025-2xx, 4xx
108.04 Service
Magenta Printhead
The magenta printhead mirror motors
lost motor lock.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
108.05 Service
Magenta Printhead
Failure reading NVRAM from the
magenta printhead.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
108.06 Service
Magenta Printhead
The magenta printhead thermistor is
open.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
108.07 Service
Magenta Printhead
The magenta printhead thermistor is
shorted to ground.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
108.08 Service
Magenta Printhead
The magenta laser showed bad in
testing.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
108.09 Service
Magenta Printhead
SOS/EOS measurement did not
complete.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
108.10 Service
Magenta Printhead
Bad SOS/EOS measurement. Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
108.11 Service
Magenta Printhead
Failure writing data tot he printhead. Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
108.12 Service
Magenta Printhead
Failure reading data from the
printhead.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
108.13 Service
Magenta Printhead
Printhead declared error. Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
109.xx Service
Black Printhead
Black printhead error. Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
109.01 Service
Black Printhead
The black printhead lost HSYNC. Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
109.02 Service
Black Printhead
The black printhead failed to complete
servo.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
109.03 Service
Black Printhead
The black printhead mirror motors
failed to achieve lock.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
109.04 Service
Black Printhead
The black printhead mirror motors lost
motor lock.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
109.05 Service
Black Printhead
Failure reading NVRAM from
printhead.
Perform a POR. If the problem persists, go
to “Printhead service check” on
page 2-51.
Service error messages (1xx, 9xx) (continued)
Error code Description Action
To Next Page
Loading...
