4 Load the paper, and then adjust the paper guides so that they lightly touch the edges of the paper stack.
• Load letter, A4, and transparencies with the recommended print side facedown and the long edge of the paper
entering the printer first.
• Load A3, A5, B4, folio, legal, and statement paper with the recommended print side facedown and the short
edge of the paper entering the printer first.
Notes:
– Adjust the additional paper guide to accommodate SRA3 and 12 x 19 paper sizes.
– Do not exceed the maximum stack height by forcing paper under the stack height limiter.
• Load envelopes with the flap side up.
Warning—Potential Damage: Never use envelopes with stamps, clasps, snaps, windows, coated linings, or
self‑stick adhesives. These envelopes may severely damage the printer.
Note: Load only one size and type of paper at a time.
5 Make sure the paper is as far into the multipurpose feeder as it will go with very gentle pushing. Paper should lie
flat in the multipurpose feeder. Make sure the paper fits loosely in the multipurpose feeder and is not bent or
wrinkled.
6 From the control panel, set the Paper Size and Paper Type.
Loading paper and specialty media 33
To Next Page
Loading...
