Lexmark C935 Series - Bin Setup Menu

Menu item Description
Portrait Width
3–48 inches
76–1219 mm
Sets the portrait width
Notes:
• If the width exceeds the maximum, the printer uses the maximum
width allowed.
• 12 inches is the US factory default setting. Inches can be increased in
0.01‑inch increments.
• 305 mm is the international factory default setting. Millimeters can
be increased in 1‑mm increments.
Portrait Height
3–48 inches
76–1219 mm
Sets the portrait height
Notes:
• If the height exceeds the maximum, the printer uses the maximum
height allowed.
• 19 inches is the US factory default setting. Inches can be increased in
0.01‑inch increments.
• 483 mm is the international factory default setting. Millimeters can
be increased in 1‑mm increments.
Feed Direction
Short Edge
Long Edge
Specifies the feed direction
Notes:
• Short Edge is the factory default setting.
• Long Edge appears only if the longest edge is shorter than the
maximum length supported in the tray.
Bin Setup menu
Menu Item Description
Output Bin
Standard Bin
Bin 1
Bin 2
Identifies installed output bins
Note: Standard Bin is the factory default setting.
Understanding printer menus 81