4 After installing the new control panel, start the printer into diagnostics mode, and allow the printer to go
through a complete startup cycle and the display to go to Ready.
5 If the problems persist, leave the new control panel in the machine, place the old controller board back in
the machine, and start it up. After the machine startup, shut down the machine, and install the new controller
board. After installing the new controller board, restart the machine, and let it go through the startup cycle.
After this procedure is completed successfully, there is no need to adjust any settings.
If the above procedure fails, you must contact the technical support center for further instructions.
Restoring the printer configuration after replacing the controller board
Restore the printer to its correct configuration to complete the replacement service. Use the Service Restore
Tool to download the software bundle, and then flash the printer settings and embedded solutions.
Note: The software bundle contains the latest version of the
firmware,
applications, and software licenses
from the Lexmark Virtual Solutions Center (VSC). The printer
firmware
may be at a
dierent
level from what
was used before replacing the controller board.
Using the Service Restore Tool
1
Go to https://cdp.lexmark.com/service-restore-tool/ to access the tool.
2 Log in using your Lexmark or partner login.
If your login fails, then contact your next level of support.
3 Enter the printer serial number, and then submit the information.
Note: Make sure that the serial number that appears on the
verification
screen is correct.
4514-330
Parts removal
185
To Next Page
Loading...
