2 Flex the sheets of paper back and forth to loosen them, and then fan them. Do not fold or crease the paper.
Straighten the edges on a level surface.
3 Reload paper into the multipurpose feeder.
Note: Make sure the paper guide lightly rests against the edge of the paper.
4 From the printer control panel, press to clear the message and continue printing.
200 paper jams
200 paper jam messages
Notes:
• Some error messages are applicable only to printer models with a polygon LSU (laser scanning unit).
• If the sixth digit character assigned to the serial number of the printer is in the P–Z range, then the
printer is installed with a polygon LSU (example: 4514 2ZHH 007CR).
Error code Description Action
200.01 Input sensor covered during warm-up sequence. Go to
“Sensor (input) static jam service check”
on page 89.
200.02 Input sensor covered too quickly. Go to
“Sensor (input) early/late arriving service
check” on page 90.
200.03 Page did not reach input sensor or was late
reaching input sensor, but was successfully
picked from the source.
Go to
“Sensor (input) early/late arriving service
check” on page 90.
200.05 Input sensor covered too long. Source = [x]. Go to
“Sensor (input) early/late arriving service
check” on page 90.
200.08 Page arrive at input senor at unexpected time. Go to
“Sensor (input) early/late arriving service
check” on page 90.
4514-330
Diagnostics and troubleshooting
87
To Next Page
Loading...
