c Apply RheoGel 793 to the point of contact to the lower edge (B) where the wiper bracket glides.
Trailing edge sensor removal
1 Remove the left cover. See “Left cover removal” on page 207.
2 Remove the right cover. See “Right cover removal” on page 222.
3 Remove the rear door and cover. See “Rear door and cover removal” on page 270.
4 Remove the power supply. See “Power supply removal” on page 252.
5 Remove the power supply shield. See “Power supply shield removal” on page 253.
6 Remove the duplex. See “Duplex removal” on page 254.
7 Disconnect the cable JACM1 from the controller board, and cut it near the frame.
4514-330
Parts removal
260
To Next Page
Loading...
