Lexmark MS312 - Page 88

Error code Description Action
200.09 Printhead did not receive proper motor feedback
to start laser servo.
Go to
“Sensor (input) image jam service check”
on page 91.
200.10 Printhead motor not locked when media reaches
the input sensor.
Go to
“Sensor (input) image jam service check”
on page 91.
200.11 Printhead motor fell out of lock after page reaches
the input sensor.
Go to
“Sensor (input) image jam service check”
on page 91.
Mirror motor got locked, and then lost it again
before the initial lock timeout.
Go to
“Laser scanning unit (LSU) service check”
on page 125.
200.12 Printhead was not ready for media. Go to
“Sensor (input) image jam service check”
on page 91.
200.13 Media at input sensor is not the next media to be
imaged.
Go to
“Sensor (input) image jam service check”
on page 91.
200.14 Media reached the input sensor before EP was
ready.
Go to
“Sensor (input) image jam service check”
on page 91.
200.15 Input sensor covered too long. Source = [x]. Go to
“Sensor (input) early/late arriving service
check” on page 90.
200.16 Fuser motor stalled. Go to
“Main drive motor control jam service
check” on page 92.
200.21 No response from paper port driver while waiting
for the source to deactivate the Input Source
Ready flag to indicate it has initiated picking.
Go to
“Sensor (input) early/late arriving service
check” on page 90.
200.23 Laser servo never started due to potential conflict
with the transfer servo.
Go to
“Sensor (input) image jam service check”
on page 91.
200.24 Measured gap at input sensor too small to meet
video delivery requirements. (Not enough time
since prior image
finished
to start new image).
Go to
“Sensor (input) image jam service check”
on page 91.
200.25 Input sensor covered too long. Source = [x]. Go to
“Sensor (input) early/late arriving service
check” on page 90.
200.29 Printhead drive control out of range due to an
external event beyond what the control is
designed to handle.
Go to
“Sensor (input) image jam service check”
on page 91.
200.30 Invalid printhead NVRAM. Go to
“Sensor (input) image jam service check”
on page 91.
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred.
Go to
“Sensor (input) early/late arriving service
check” on page 90.
200.32 Detected cover switch bounce. Go to
“Sensor (input) early/late arriving service
check” on page 90.
Printhead lost HSYNCs due to a glitch with the
laser safety interlock, for example, bouncy cover
switch.
Go to
“Laser scanning unit (LSU) service check”
on page 125.
200.33 Input sensor covered too quickly. Go to
“Sensor (input) early/late arriving service
check” on page 90.
4514-330
Diagnostics and troubleshooting
88