Use To
Hole Punch Mode
2 holes
3 holes
4 holes
Specify the number of holes to be made on the prints.
Notes:
• “3 holes” is the U.S. factory default setting. “4 holes” is the international
factory default setting.
• This menu appears only when a supported staple, hole punch finisher is
installed.
Duplex Binding
Long Edge
Short Edge
Define the way duplexed pages are bound and printed.
Notes:
• Long Edge assumes binding along the long edge of the page (left edge for
portrait and top edge for landscape). This is the factory default setting.
• Short Edge assumes binding along the short edge of the page (top edge for
portrait and left edge for landscape).
Paper Saver Orientation
Auto
Landscape
Portrait
Specify the orientation of a multiple‑page document.
Notes:
• Auto is the factory default setting.
• This setting affects jobs if the value of the Paper Saver setting in the same
menu is not set to Off.
Paper Saver
Off
2‑Up
3‑Up
4‑Up
6‑Up
9‑Up
12‑Up
16‑Up
Specify that multiple‑page images be printed on one side of a paper.
Notes:
• Off is the factory default setting.
• The number selected is the number of page images that will print per side.
Paper Saver Border
None
Solid
Print a border on each page image when using N‑Up (pages per side).
Notes:
• None is the factory default setting.
• This setting affects jobs if the value of the Paper Saver setting in the same
menu is not set to Off.
Paper Saver Ordering
Horizontal
Reverse Horizontal
Reverse Vertical
Vertical
Specify the positioning of multiple‑page images when using N‑Up (pages per side).
Notes:
• Horizontal is the factory default setting.
• Positioning depends on the number of page images and whether they are in
portrait or landscape orientation.
• This setting affects jobs if the value of the Paper Saver setting in the same
menu is not set to Off.
1
This menu appears only in touch‑screen printer models.
2
This menu appears only in non‑touch‑screen printer models.
Understanding the printer menus 226
To Next Page
Loading...
