Use To
Export Configuration Package
Export
Export the printer configuration package to a flash drive.
Note: The configuration package cannot be exported unless a
flash drive is attached to the printer.
Flash Drive Menu
Print Settings menu
Use To
Copies
1–999
Specify a default number of copies for each print job.
Note: 1 is the factory default setting.
Paper Source
Tray [x]
Multipurpose Feeder
1
MP Feeder
2
Manual Paper
Manual Envelope
Set a default paper source for all print jobs.
Note: Tray 1 is the factory default setting.
Collate
(1,1,1) (2,2,2)
(1,2,3) (1,2,3)
Stack the pages of a print job in sequence when printing multiple copies.
Note: “(1,2,3) (1,2,3)” is the factory default setting.
Sides (Duplex)
1 sided
2 sided
Specify whether prints are on one side or on both sides of the page.
Note: 1 sided is the factory default setting.
Staple
Off
On
Specify whether prints are stapled.
Notes:
• Off is the factory default setting.
• On allows the printer to staple print jobs.
• This menu appears only when a supported staple finisher is installed.
Hole Punch
Off
On
Specify whether prints have holes for binding.
Notes:
• Off is the factory default setting.
• This menu appears only when a supported staple, hole punch finisher is
installed.
1
This menu appears only in touch‑screen printer models.
2
This menu appears only in non‑touch‑screen printer models.
Understanding the printer menus 225
To Next Page
Loading...
