PPDS font error [50]
Try one or more of the following:
• From the printer control panel, select Continue to clear the message and continue printing. For non‑touch‑screen
printer models, press
to confirm.
• If the printer cannot find the requested font, then from the printer control panel, navigate to:
PPDS menu > Best Fit > On
The printer will find a similar font and reformat the affected text.
• Cancel the current print job.
Paper changes needed
Try one or more of the following:
• Select Use current supplies on the printer control panel to clear the message and continue printing.
For non-touch-screen printer models, press
to confirm.
• Cancel the current print job.
Parallel port [x] disabled [56]
Try one or more of the following:
• Select Continue to clear the message. For non-touch-screen printer models, press to confirm.
The printer discards any data received through the parallel port.
• Select Reset active bin to reset the bin for a linked set of bins.
Reattach bin [x]
Try one or more of the following:
• Turn off the printer, and then turn it back on.
• Reattach the specified bin.
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the specified bin.
4 Reattach the bin.
5 Connect the power cord to a properly grounded electrical outlet.
6 Turn the printer back on.
• Remove the specified bin:
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
Troubleshooting 292
To Next Page
Loading...
