24
Set up the printer
1
Pull open trays 2, 3, and 4.
Take care not to tip the printer.
2
Attach two locking clips to the
left and right sides of the trays,
as shown.
a
Insert the bottom of a clip
into the slot on tray 4.
b
Attach the top of the clip to
tray 3 with a screw.
c
Repeat steps a and b to
attach locking clips between
trays 2 and 3.
3
Close the trays.
4
Move to the back of the printer.
5
Attach four more locking clips
to the back of the printer, as
shown.
6
Skip to “Removing packaging
from the trays” on page 28.
To Next Page
Loading...
