56
Install memory and option cards
Attaching an
adapter ribbon cable
If you bought an adapter ribbon cable for
a separate hard disk, follow these
instructions to attach the cable to the
hard disk.
Note:
The adapter ribbon cable comes
with screws for securing the hard disk to
the metal bracket inside the printer.
If your hard disk already has a ribbon
cable attached, go to “Attaching a hard
disk” on page 57.
1
Locate the 47-hole connector
on the ribbon cable.
One of the 50-hole connectors
has three holes plugged.
2
Attach the 47-hole connector
to the hard disk connector.
When correctly installed, the
stripe on the ribbon cable is ori-
ented as shown.
3
Continue with “Attaching a hard
disk” on page 57.
Stripe
To Next Page
Loading...
