Lexmark T656dne - Output Expander Sensor (Deflector Gate HP) Removal

4-172 Service Manual
4062-XXX
Go Back
Previous
Next
Output expander sensor (deflector gate HP) removal
1. Remove the output expander left inner cover. Go to “Output expander left inner cover removal” on
page 4-163.
2. Remove the four screws securing the left frame assembly to the option.
3. Pull the left frame assembly out far enough to gain access to the sensor (deflector gate HP).
4. Release the tabs securing the sensor (deflector gate HP) and remove.
5. Disconnect the harness to the sensor and remove.