15 Remove the label covering the USB port on the back of the printer.
16 Connect the cables in the following order:
a Temporarily connect a USB cable between the computer on the wireless network and the printer.
Note: After the printer is configured, the software will instruct you to disconnect the temporary USB cable
so you can print wirelessly.
b If you plan to set up fax now, then connect the fax cables. See the User's Guide on the Software and
Documentation CD for help deciding how to connect the cables.
17 Follow the on‑screen instructions to complete the software installation.
Note: Basic is the recommended path to choose. Choose Advanced only if you want to customize your
installation or if your network uses 802.1x security.
18 To allow other computers on the wireless network to use the wireless printer, follow steps 10 through 14 for each
computer.
Additional printer setup 57
To Next Page
Loading...
Need help?
General
