15
Complete the hardware setup
Turning on the controlhe control
unit and printerd printer
1 Plug the printer and the power
supply line cord into properly
grounded electrical outlets.
2 Turn the printer on.
3 Install the power switch cover (see
“Installing the printer operator
panel cover” on page 13 for
illustration):
a Slide the locking tabs on the
bottom of the cover into the
slots on the operator panel,
b Push the cover down until the
top two tabs snap into place.
4 Turn on the control unit.
The MFP requires time to warm up after quires time to warm up after
you turn it on. During this period, the
message Please wait while the device
initializes appears on the touch screen.
After the MFP completes its tests, the
Home screen is displayed on the touch
screen.
To Next Page
Loading...
